Oil furnaces









Oil Furnace Replacement Electrodes: How to Remove Old Electrodes

Oil furnace replacement is something that should not be taken lightly. You will need to make sure that you use caution and know what to and what not to do. This is especially true when it comes to electrodes. You will find that there are a lot of things that you will have to keep in mind to make sure that the job gets done safely and correctly. Whenever you are removing old electrodes you will have to make sure that you are able to do this in a way that will keep the electrodes from getting too close to the other as this could be very dangerous.

Materials Needed
  • Screwdriver
  • Model Number of Electrode
  • Paint Thinner
  • Rag
  • File
Step 1 – Study Electrodes

The first thing that you will need to do is get a good look at your electrodes. It is a good idea for you to know if they are going to be replaced or not before you take them out. Look for cracks. Your electrodes are more than likely going to be somewhat dirty so you will need to remove them regardless to clean them. However, get a good idea of what your next step should be before the actual removal takes place.

Step 2 – Loosen

Whenever you need to remove your electrodes you will need to begin by getting out your screwdriver and loosening up the screws. Look at the sleeve of the electrodes to see if there is any damage that has been done to them. Once the screws that hold the electrodes in place have been loosened, it is time to get an even better look at your electrodes. Make sure that you are able to get the model number off of the electrodes if replacement is necessary.

Step 3 – Removal

Whenever you are removing the electrodes make sure that you use extreme caution. You will need to make sure that the electrodes do not come into contact with the other. If they touch then a spark will be caused. This could result in a fire or even an explosion if you are not careful. This is why it is important for you to slow down and take your time so that you are able to get your electrodes out without putting you or others in danger.

Step 4 – Clean

You may simply need to clean your electrodes as opposed to replace them. However, you may need to clean them before you can tell if they need to be replaced. Either way, cleaning your electrodes is not a difficult task. Get your paint thinner out and make your rag damp with it. You will need to clean the sleeve with this. This could take some time as the soot can be difficult to remove without a few coats of thinner.

Step 5 – File

Once the sleeve has been cleaned thoroughly you are ready to move on to your electrodes. Get out your file and get the ends of the electrodes filed down into sharp points before you put them back into place.



Oil Furnace Parts

Gas Furnace Pilot Light

Oil Furnace Filter

Water Tube Boiler Operation

Energy Efficient Boilers

Gas Furnace Thermocouple

Boiler Control Wiring

Furnace Blower

Dusty Furnace Blower

Replacing The Belt On a Furnace Blower

Wood Furnace Blower

Oil Furnace Repair

Furnace Humidifier Troubleshooting

Site map









Copyright 2011